ECX Torment Instruction Manual download pdf (Page 9)

torment

™

MAINTENANCE

ELECTRONIC SPEED CONTROL (ESC)

Programming: The ESC comes with two jumpers pre-installed in

theREV:ONandBATT:Ni-MHcongurations.

To disable reverse or change battery type to Li-Po, disconnect the

jumper from the default port and connect it to the desired port.

Power off the ESC, then power it back on.

If the jumpers are lost or not installed, the ESC will default to

REV:ONandBATT:Li-Po.

ELECTRICAL LAYOUT

For correct operation, Channels 1 and 2

must be used as shown in the wiring diagram.

The motor can be disconnected from the ESC

at the connectors in the wiring.

Part # Description

A DYNS1215

Motor

B DYN1062EC

Battery 8.4V

C SPMS603

Waterproof Steering

Servo

D SPMSR201

Waterproof Receiver

E DYNS2211

Waterproof Electronic

Speed Control (ESC)

Channel 1

Channel 2

Operation LED Status Sound at Power UP

Stop OFF

Forward Blinks

Forward (full speed) Solid

Reverse Blinks

Brake Blinks

Brake (full brake) Solid

Ni-MH/Ni-Cd Battery 1 Short Beep

2S Li-Po Battery 2 Short Beeps

ESC Ready 1 Long Beep

Battery Low Voltage Blinks

Overheat Blinks

EC3EC3

LED

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

ECX Torment Instruction Manual Page 9

Comments to this Manuals

Related products and manuals for Remote controlled toys ECX Torment